5
West Mountain Radio
Operating Manual
For a more exhaustive list we have a web resource which can be accessed
here:
http://www.westmountainradio.com/isc-finder.php
Installing the ISC
The DXpro is shipped without the metal top cover screwed on to facilitate first-
time installation of the ISC.
Locate the ISC header on the circuit board. It is 2 rows
of 14 pins designated P1. The orientation is pin 1 on
the left-hand side if the unit’s front panel controls are
facing you.
Place the correct ISC for your transceiver over the
pins and push firmly down. All pins should be covered
by the black plastic header block. Be careful not to
miss a row or column of pins.
Refer to the image if necessary.
Once the ISC has been installed you may carefully
attach the metal top cover and the sheet metal case screws can be inserted. As
these screws will cut the thread in the screw holes, a little force may be needed
the first time you do this.