6
PANEL DESCRIPTION
FRONT PANEL
-
MICROPHONE CONNECTOR,
8-Pin Screw-on Microphone Connector – connects almost any make or
model radio microphone to the
RIGblaster duo
for use with any other or the same make or model radio.
- “ph”
HEADPHONE MONITOR JACK
– Accepts stereo headphones with a 1/4 inch plug – may be used with
supplied adaptor for headphones with 1/8 inch plugs.
-
“xmit select”
TRANSMIT SELECTOR SWITCH –
Selects either radio A or radio B to transmit with both a
microphone or computer audio.
- “xmit level” TRANSMIT LEVEL SET
– For adjusting the audio transmit drive level coming from the
computer audio output into the Mic input of the radio selected for transmit.
-
“rx level” MASTER MONITOR LEVEL SET”
– For adjusting the master monitor audio level (volume) for the
entire station - monitored on headphones and/or speakers.
-
“radio A” AUDIO MONITOR SELECTOR SWITCH
– Selects the audio output of radio A, in three positions:
Off, headphones only, and speakers plus headphones. (also routes the receive audio to the computer for
software receive in either headphone or speaker on positions, but only with the default setting of the PC monitor
jumpers)
-
“radio B” AUDIO MONITOR SELECTOR SWITCH
– Same as above but selects radio B.
-
“PC”
AUDIO MONITOR SELECTOR SWITCH
– Same as both above but selects audio from the computer.
-
“ph level” HEADPHONE LEVEL SET”
– For adjusting the headphone monitor audio level (volume) in
relation to the master volume. It is a slave volume control below the master level that sets the headphone volume
in relation to station master volume.
-
“c. s.” LED
– A yellow LED indicating that the
RIGblaster duo
is feeding computer audio (CS:
Computer Sound) to the radio selected for transmit, not microphone audio. It will come on only if activated by
sound card software, thus indicating that the
RIGblaster
has automatically switched the audio to the
computer. Note that it will turn off, even while activated, if the PTT is overridden by the station microphone PTT
switch or rear panel connected foot switch.
-
“ptt” LED
– This red LED indicates when PTT is activated directly by your mic’s PTT button, by your foot
switch or indirectly via software through the USB virtual serial port interface.
Summary of Contents for RIGblaster duo
Page 19: ...19 ...