SAK Tillers
Page 12 of 23
WORKING DEPTH ADJUSTMENT
The working depth of the equipment depends on the position of the lateral skids.
If the skids are raised, the working depth increases; if the skids are lowered, the working depth
decreases.
Make sure that the skids are set at the same height on both sides.
To adjust the working depth on the SAK tillers loosen
and remove nut A (picture 4) and adjust the skid height
according to the holes B. When the adjustment is
completed, tighten the screws.
DRAG BOARD ADJUSTMENT
The height of the rear drag board can be
adjusted, making the ground more compact
and smooth. Release the chain A (picture 5)
and reengage it at the desired height B.
These activities must be carried out with the engine off, the power take
off disengaged and the hand brake applied. If needed, lift the equipment
and place it on supports, thus preventing any injuries that might be
caused by a sudden fall of the equipment.
