7
9.
Make sure that all parts are properly tightened before you use the exercise cycle.
Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
8. Identify the Left Pedal (10), which is marked with a
sticker. Using an adjustable spanner,
firmly tighten
the Left Pedal
counterclockwise
into the left arm of the
Crank (12). Tighten the Right Pedal (not shown)
clock-
wise
into the right arm of the Crank.
Important:
Tighten both Pedals as firmly as possible. After
using the exercise cycle for one week, retighten
the Pedals. For best performance, keep the Pedals
tightened.
8
10
12
7
7. Attach the Handlebar (3) to the bracket on the Upright (2)
with the Handlebar Clamp (18), an M5 x 54mm Button
Screw (48), an M5 Curved Washer (49), and the
Adjustment Handle (17).
Be careful to avoid pinching
the Pulse and Upper Pulse Wires (64, 66).
Connect the Pulse Wires (64) to the Upper Pulse Wires
(66) as shown.
18
2
17
3
64
49
66
48
6. Have another person hold the Console (5) near the
Upright (2). Connect the console wire to the Upper
Wire Harness (56). Then, connect the console pulse
wires to the Upper Pulse Wires (66) as shown.
Push the excess wires downward into the Upright (2).
Attach the Console (5) to the Upright with two
M5 x 12mm Screws (52).
Be careful to avoid pinch-
ing the wires.
5
6
Be careful to
avoid pinching
the wires.
2
52
56
Console
Wire
Console
Pulse Wires
66
