12
When you turn
on the console,
the scan mode
will be selected
automatically.
One indicator will
appear below the
word Scan to
show that the
scan mode is
selected, and a second indicator will show which
information is currently displayed. Note: If you
have selected a different mode, press the Display
button repeatedly to reselect the Scan mode.
To select the
speed, time, dis-
tance, or calories
mode for contin-
uous display,
press the Display
button repeated-
ly. The indicators
will show which mode is selected. Make sure that
there is not an indicator below the word Scan.
Note: The con-
sole can show
speed and dis-
tance in either
miles or kilome-
ters.
The letters
“mph” or “km/h”
will appear in the
display to show which unit of measurement is
selected. To change the unit of measurement, first
hold down the On/Reset button for a few seconds.
An “E” (for English) or an “M” (for metric) will
appear in the display. Press the Display button to
change the unit of measurement. Note: When the
batteries are replaced, it may be necessary to res-
elect the desired unit of measurement.
To reset the display, press the On/Reset button.
To pause the console, stop pedaling. If the time is
displayed, it will flash. To continue your workout,
simply resume pedaling.
4. Measure your heart rate if desired.
To measure your
heart rate,
stop
pedaling
and
place your thumb
on the pulse sen-
sor.
Do not
press too hard,
or the circula-
tion in your thumb will be restricted and your
pulse will not be detected.
After a few seconds,
the heart-shaped indicator in the display will begin
to flash, two dashes will appear, and then your
heart rate will be shown. Hold your thumb on the
pulse sensor for about 15 seconds for the most
accurate reading.
If the displayed heart rate appears to be too high
or too low, or if your heart rate is not displayed, lift
your thumb off the pulse sensor for a few seconds.
Then, place your thumb on the pulse sensor as
described above.
Make sure that you are applying the proper
amount of pressure to the pulse sensor. Try the
pulse sensor several times until you become famil-
iar with it. Remember to stand still while measur-
ing your heart rate.
5. When you are finished exercising, the console
will turn off automatically.
If the pedals do not move for a few seconds, the
console will pause. If the pedals do not move for a
few minutes, the console will turn off and the dis-
play will be reset.
Indicators
Summary of Contents for Pursuit G 2.8
Page 17: ...17 NOTES ...
