6
2. Whilst another person lifts the back of the Frame (1),
attach the Rear Stabilizer (28) to the Frame with two
M10 x 75mm Carriage Bolts (34) and two M10 Nylon
Locknuts (33).
34
28
1
2
33
33
3. The Console (23) requires three 1.5V “AA” batteries;
alkaline batteries are recommended. Insert three bat-
teries into the battery compartment.
Make sure that
the batteries are oriented as shown by the diagram
inside the battery compartment.
23
Batteries
3
4. Whilst another person holds the Console (23) near the
Upright (2), connect the console wire to the Upper
Wire (44). Insert the console wire and the Upper Wire
into the Upright.
Attach the Console (23) to the Upright (2) with four M4
x 16mm Screws (42).
Be careful to avoid pinching
the console wire or the Upper Wire (44).
Turn the Resistance Knob (63) counterclockwise to
the lowest setting before continuing to the next
step.
4
23
2
44
63
Console Wire
42
5
1
2
33
Make sure that
the wires and
cables do not
get pinched
and damaged
during this
step.
44
53
48
55
63
59
5. Whilst another person holds the Upright (2) near the
Frame (1), connect the Upper Wire (44) to the Reed
Switch Wire (53).
Next, connect the Resistance Cable (63) to the Lower
Cable (55) in the following way:
• Refer to drawing A. Pull up on the metal bracket on
the Lower Cable (55), and insert the tip of the
Resistance Cable (63) into the wire clip inside of the
metal bracket.
• Refer to drawing B.
Firmly
pull the Resistance Cable
(63) and slide it into the metal bracket on the Lower
Cable (55) as shown.
• Refer to drawing C. Using pliers, squeeze together
the prongs on the upper end of the metal bracket.
Push the excess cable and wire down into the Frame
(1). Slide the Upright (2) onto the Frame.
Be careful
not to pinch the wires or cables.
Secure the Upright
to the Frame with two M10 x 68mm Button Bolts (48),
two M10 Split Washers (59), and two M10 Nylon
Locknuts (33).
Do not tighten the Button Bolts yet.
55
55
Metal
Bracket
B
A
C
55
63
63
63
