Wernick Xylosynth XS7s-3, Manual, Page: 15 / 18

Ethnic
105. Sitar
106. Banjo
107. Shamisen
108. Koto
109. Kalimba
110. Bag pipe
111. Fiddle
112. Shanai
Percussive
113. Tinkle Bell
114. Agogo
115. Steel Drums
116. Woodblock
117. Taiko Drum
118. Melodic Tom
119. Synth Drum
120. Reverse Cymbal
Sound Effects
121. Guitar Fret Noise
122. Breath Noise
123. Seashore
124. Bird Tweet
125. Telephone Ring
126. Helicopter
127. Applause
128. Gunshot
For Channel 10 and any program number the following sounds are played when striking
different keys. The numbers here refer to the note numbers where 60 is middle C.
35 Bass Drum 36 Bass Drum 1 37 Side Stick
38 Snare Drum 1 39 Hand Clap 40 Snare Drum 2
41 Low Floor Tom 42 Closed Hi Hat 43 High Floor Tom
44 Pedal Hi-Hat 45 Low Tom 46 Open Hi-Hat
47 Low/Mid Tom 48 Hi/Mid Tom 49 Crash Cymbal 1
50 High Tom 51 Ride Cymbal 1 52 Chinese Cymbal
53 Ride Bell 54 Tambourine 55 Splash Cymbal
56 Cowbell 57 Crash Cymbal 2 58 Vibraslap
59 Ride Cymbal 2 60 Hi Bongo 61 Low Bongo
62 Mute Hi Conga 63 Open Hi Conga 64 Low Conga
65 High Timbale 66 Low Timbale 67 High Agogo
68 Low Agogo 69 Cabasa 70 Maracas
71 Short Whistle 72 Long Whistle 73 Short Guiro
74 Long Guiro 75 Claves Claves 76 Hi Wood Block
77 Low Wood Block 78 Mute Cuica 79 Open Cuica
80 Mute Triangle 81 Open Triangle
13.0 How to Replace a Key
Tools Required
‘Pozi Drive’ Screwdriver. Bit size PZ1 & referred to as cross head and a 7mm socket or
spanner for M4 nuts.
General Notes
Replacing a Key should take less than 20 minutes if you have carried out this operation
before. This time can be reduced if you use a Pozi (PZ1) bit with a battery operated drill to
remove & fix screws that hold the Bottom Panels. But only use a battery operated drill if
you are proficient with using one. If using a battery powered drill take special care by
engaging the bit properly & starting slowly with some end pressure to stop the bit slipping
but also not too hard to damage the threads. Make sure not to over tighten the screws that
hold the bottom cover and this means carrying out the final tightening of the screws by
15