Wenglor OY1TA603P0003, Operating Instructions Manual

Page: 41 / 64

41
Sensors for your success www.wenglor.com Sensors for your success www.wenglor.com
EN
6. Initial Start-Up
6.1 Initial Start-Up
Connect the sensor to supply power (18 to 30 V DC). The display view appears.
The sensor is ready for operation after 2 seconds. The following table provides an overview of measured value
deviations during the warm-up phase.
Time (min.) 0 1 2 5 10 15
Deviation (mm) ±10 ±7 ±6 ±2 ±1 0
Switch to the configuration menu by pressing any key.
Note:
If no settings are adjusted in the configuration menu for a period of 30 s, the sensor is automatically returned to
the read-out view. The sensor accesses the last used menu view when a key is once again activated.
If a setting is adjusted, it becomes active when the configuration menu is exited.
The keys are used for navigation, and for configuring settings.
Important:
Do not use any sharp objects to press the keys when configuring settings, because they might otherwise
be damaged.

Navigation up.

Navigation down.

Acknowledge the selected menu item (arrow points towards the display).

Accept the selected setting, exit the menu (arrow points away from the display).