Wenglor OY1TA603P0003, Operating Instructions Manual

Page: 40 / 64

40
Sensors for your success www.wenglor.com Sensors for your success www.wenglor.com
EN
4.3 The Control Panel
A warning triangle in the display indicates that
the sensor receives a lot of light, e.g. through a
glossy surface of the object. The measurement
value could be around 400 mm too low in this
case. To find a remedy, see the mounting instruc-
tions in case of glossy surfaces.
4.4 Accessories
Suiting Connection Technology No.
2
Suiting Mounting Technology No.
5. Installation Instructions
All applicable electrical and mechanical regulations, standards and safety precautions must be adhered to
when installing and operating the sensor. The sensor must be protected against mechanical influences. Install
the device such that its installation position cannot be inadvertently changed. The wenglor mounting system is
recommended for installing the sensor. In order to obtain best possible results, the device’s optics should be
aligned at a right angle to the direction in which the objects are conveyed.
At brilliant surfaces, mount the sensor
in an angle of 5° to avoid a direct
reflexion beam into the lens.
SENSOR
5
Display
Control key