![background image](http://html1.mh-extra.com/html/wen/pw3100/pw3100_manual_956477021.webp)
CHECKING DETERGENT SIPHONING TUBE
1. Check the detergent siphoning tube for clogs, leaks, or tears.
2. Make sure the tube fits tightly on the pump fitting.
3. Replace siphoning tube if damaged.
HIGH PRESSURE HOSE
1. Inspect hose for cuts, bulges, or leaks which can develop from kinking or wear. If damage is
found, immediately replace hose.
2. Inspect couplings for damage. Immediately replace hose if damage is found.
WARNING:
Never repair a high pressure hose or use unit if the hose is damaged. If the hose is
damaged. replace it. Contact WEN customer service for assistance.
SPRAY GUN
1. Make sure the spray gun is connected securely.
2. Inspect the spray gun safety and make sure the spray gun trigger springs back upon release.
SPRAY NOZZLE
If a pulsing sensation is felt while squeezing the trigger, the spray nozzle may be dirty or clogged,
and should be cleaned immediately. To clean the nozzle:
1. Shut off the engine and turn off the water.
2. Remove the nozzle from the spray wand, making sure that the nozzle is pointing away from you
and in a safe direction.
3. Use the nozzle cleaner or a small paper clip to dislodge any foreign materials which are clogging or
restricting the spray tip. Flush debris out of the nozzle by back flushing with a garden hose for 30-60
seconds.
4. Reconnect the nozzle to the spray wand.
5. Turn the water supply back on and start engine.
MAINTENANCE
CAUTION:
Never place any type of storage cover on the pressure washer while it is still hot.
If the pressure washer is being stored for short periods of time (30 to 60 days), add stabilized fuel to
the fuel tank until full.
NOTE:
Filling the tank reduces the amount of air in the tank and helps reduce deterioration of fuel.
Run the engine for 2 – 3 minutes allowing stabilized fuel mixture to circulate through the carburetor.
STORAGE & TRANSPORT
Nozzle Cleaner
21