TIP: needle-nose pliers are helpful for gently working the hoses off the barbed fittings.
4. Use the 8mm wrench or socket to remove the two screws from the front of the detergent tank as
shown in Fig. 3 below.
5. As viewed from the front of the unit, remove the wheel on the right. To do this:
1. Remove the cotter pin shown in Fig. 4 below. Slip-joint pliers may be helpful.
2. Slide the wheel and axle pin out of the frame. NOTE: as you do this, the pressure washer
will want to tilt to this side. Put a block of wood or other sturdy object under the frame to
prevent it from tilting over.
6. Remove the other screw that holds the detergent tank, as shown in Fig. 5 below.
Fig. 3: Remove these screws.
Fig. 4: Remove cotter pin.
