Wen MSA658, Instruction Manual

Page: 12 / 16

What’s Needed:
ATTACH THE POWER TOOL
Now is the moment you’ve been waiting for. Unplug
and bring over your favorite power tool. Make sure
the weight does not exceed the stand capacity and
the tool is wider than it is tall. Place the power tool
on the center of the tabletop to maximize stability.
Orient it so you will be operating the tool on the side
perpendicular to the direction of the stand’s travel.
Mount the power tool onto the stand using four
M8x60 bolts (Fig. 7 - 1), four 8mm washers (Fig. 7 -
2), and four M8 hex nuts (Fig. 7 - 3). Check to make
sure the tool is securely mounted and the stand is
stable.
WARNING! Only mount the power tool such
that the direction of the cutting or movement of
the workpiece is perpendicular to the wheels.
Never mount a tool in a way where the tool would
be pushed in the direction of the wheels.
ASSEMBLY & ADJUSTMENTS
TO MOVE THE STAND
Hold the tabletop and step down on the foot pedal to un-
lock and engage the wheel. Carefully move the stand to a
new location.
CAUTION! Tipping can occur if wheels are stopped
abruptly by debris on the floor.
TO SET DOWN THE STAND
Hold the tabletop and push the foot pedal up to raise the
wheel. Support the weight as the stand drops into the
locked position.
OPERATION
Bolts M8x60
Full Thread (4)
Washers (4)
Hex Nuts (4)
Fig. 7
2
1
3
LOCK LOCK
UNLOCK UNLOCK
12
Wheel
Direction
Wheel
Direction
Planer Feed
Direction
Saw Sliding
Direction
Fig. 9
Fig. 8