![background image](http://html1.mh-extra.com/html/wen/jt3062/jt3062_instruction-manual_956454017.webp)
MAINTENANCE
WARNING!
To avoid cuts, wear cut-proof or cut-resistant gloves when performing maintenance work on the
blades. Remove the gloves before operating the jointer.
REPLACING BLADES
1. Make sure the switch is in the OFF position and that the cord is un-
plugged before replacing the blades.
2. Loosen the two screws holding the base of the blade guard and then
remove the blade guard (Fig. 18 - 1).
3. Loosen and remove the four blade lock screws (Fig. 18 - 1) securing
the blade (Fig. 18 - 2) and the blade clamp (Fig. 18 - 3).
4. Lift the blade and the blade clamp from the cutterhead, cleaning any
sawdust and resin buildup from the cutterhead, the blade and the blade
clamp.
5. Place the new blade against the blade clamp and replace it in the
cutterhead, securing it in place with the four blade lock screws. Do not
tighten the blade lock screws until you have checked that the blade
height is level and properly aligned.
Fig. 18
1
3
2
17
6. Adjust as required, using a straight edge as described in “Adjust the
Blade Height” on p. 15 of this manual. Tighten the blade lock screws, check the blade adjustment, and make sure
the blade is still level with the outfeed table. Repeat this procedure to replace the other blade.
7. Replace the blade guard. Make sure the cutterhead lock is disengaged from the cutterhead.
CLEANING & STORAGE
1. After every operation, use a vacuum to remove dust and chips from the tool surfaces, motor housing and work
area. Keep the ventilation openings free from dust and debris to prevent the motor from overheating.
2. Wipe the tool surfaces clean with a soft cloth or brush. Make sure water does not get into the tool.
3. Lubricate the table bracket and locking knobs if they become difficult to use.
Summary of Contents for JT3062
Page 23: ...23 NOTES...