![background image](http://html1.mh-extra.com/html/wen/df1200x/df1200x_instruction-manual_956387022.webp)
CALCULATING THE WATTAGE OF YOUR DEVICE(S)
Connect electrical devices running on AC current according to their wattage requirements. Calculate the total run-
ning wattage and starting wattage of the device(s) you wish to connect, and MAKE SURE that they are within the
capacity of your generator and the capacity of each individual outlet.
Generator
Wattage
Capacity
GENERATOR RUNNING (RATED) WATTS
GENERATOR STARTING (SURGE) WATTS
9500W (9000W LPG)
12000W (11000W LPG)
What this means:
The generator can produce a maximum of
9500W (9000W LPG) on a continuous basis
to supply ongoing power to your electronic
devices.
NOTE:
Also check the rated amperage for
each outlet and make sure not to overload
the individual outlets.
What this means:
Some devices such as box fans require short
bursts of extra power in addition to rated
wattage listed by device to start their motors.
The generator can produce a maximum watt-
age of 12000W (11000W LPG) for a short
period of time (seconds) to cover the extra
starting power required by your electronic
devices.
Electronic
Device
Wattage
Calculation
Find the wattage information of each device you plan to connect. The information should
be listed on the device or in its instruction manual, or you may refer to
Table 2 -
Estimated
Wattages of Common Electrical Appliances.
The wattage can be calculated using this equation:
Watts = Volts x Amperes
To calculate the total running watts of your
devices:
+
Add up the running wattages of all the
device(s) you plan to connect.
=
The total running (rated) wattage.
This wattage should NOT exceed the run-
ning wattage of
9500W (9000W LPG)
.
It is recommended to maintain a load at or
below 8550W (8100W LPG) (90% of the
rated output) to ensure steady voltage out-
put and to prolong the generator’s lifespan.
To calculate the total starting watts of your
devices:
+
Add up the total running wattage of all the
device(s) you plan to connect.
+
Add the single highest ADDITIONAL start-
ing wattage out of the device(s) you plan to
connect.
=
The total starting (surge) wattage.
This wattage should NOT exceed the starting
wattage of 12000W (11000W LPG).
If any of either of the total calculated running watts or starting watts is higher than the capac-
ity of your generator, adjust the load until both wattage requirements are met. Otherwise you
will overload the generator, and cause damage to the engine and your electrical device(s).
Table 1 - How to Calculate Wattages
USING YOUR GENERATOR
22
Summary of Contents for DF1200X
Page 35: ...WIRING DIAGRAM 35...