17
SANDING BELT REPLACEMENT
1. Make sure the switch is in the OFF position and the cord is
disconnected from the power source.
2. Remove the upper guard locking knob (Fig. 11 - 3) and the
upper guard (Fig. 11 - 2).
3. While holding the side cover in place, remove the three
screws and washers holding the cover in place (p. 13, Fig.
8 - 5. Fig. 9 - 1 & 2). Remove the side cover.
4. Push the shaft guard (Fig. 11 - 1) forward towards the
work table. (This will shift the middle roller forwards and
create slack in the belt.) While pushing the shaft guard for-
wards, slide the belt off of the rollers with your other hand.
5. Place a new belt on the rollers. Check that the arrow on
the back of the new belt is pointed in the direction of travel.
7. Adjust tracking (instructions on p. 13) accordingly and
reinstall the side cover, upper guard, and upper guard lock-
ing knob.
2
Fig. 11
SANDING DISC REPLACEMENT
1.Make sure the switch is in the OFF position and the cord is disconnected from the power source.
2. Remove the sanding disc table by removing the two locking knobs on either side of the sanding disc. Remove the
disc dust port by removing the three screws and washers. See figures on p. 12.
3. Remove the used sanding disc. A WEN Heat Gun
(Model Number 2020 or HG1022)
can help to soften up the
adhesive to make for an easier, cleaner removal. Wipe the sanding disc plate clean.
4. Peel the backing from the new sanding disc, align the disc with the plate and press the sanding disc firmly on to
the plate.
5. Reinstall the disc dust port, work table, and locking knobs.
MAINTENANCE
WARNING!
To avoid accidents, turn OFF and unplug the tool from the electrical outlet before cleaning, ad-
justing, or performing any maintenance work.
WARNING!
Any attempt to repair or replace electrical parts on this tool may be hazardous. Servicing of the
tool must be performed by a qualified technician. When servicing, use only identical WEN replacement parts.
Use of other parts may be hazardous or induce product failure.
1
3
