Wen 61731, Manual, Page: 12 / 20

double firing.
This firing mode is best for larger jobs where speed is more important than precision. However, there is also a
higher chance of misfiring when this mode is being used.
WARNING:
Never put your finger on the trigger unless you are prepared for operation. Unintended
nails can be discharged when the trigger is engaged and the safety bracket is pressed by accident.
PREPARATION AND ADJUSTMENTS
ADJUSTING THE FIRING MODE (Fig. 9)
The firing mode selector knob is for selecting the firing mode on your nailer. Fully understand the characteristics
and activation of each firing mode as described below.
WARNING:
To prevent injury from accidental operation, make sure the tool disconnected from the
air supply before assembly and making adjustments. Always wear Z87.1-approved safety glasses and
hearing protection during assembly, operation, and maintenance of the tool.
Single Firing Mode
Turn the knob up to select the single firing mode.
To fire a nail in this firing mode, first press down the
safety bracket and then pull the trigger. One nail will
be driven each time. Disengage both trigger and safety
bracket and repeat the activation sequence above to
drive the next nail.
The single firing mode is the preferred method for safer
operation and more detailed nailing jobs.
Multiple Firing Mode
Turn the knob down to select the multiple firing mode.
This firing mode allows you to keep the trigger engaged
while bumping the safety bracket to fire one nail after
the other. Double firing may occur if the safety bracket
is engaged between shooting nails. So make sure to re-
lease the safety bracket after driving each nail to prevent
Fig. 9
12