Wen 49103, Manual

Page: 9 / 14

KNOW YOUR SCREWDRIVER
CHARGING YOUR SCREWDRIVER
Quick Release
Chuck
LED Work Light
ON/OFF switch
Direction and Safety Switch
Battery and Charger
Indication Lights
INCLUDED ACCESSORIES :
• Charger (1)
• Belt Holster (1)
• Screwdriver Bits (3)
ATTENTION:
The battery must be charged fully before the first time use.
1. Inspect the screwdriver, battery charger and power cord for any signs of damage.
2. Plug the charger into a 120V AC power source, connecting the other end to the
receptacle on the back of the screwdriver (Fig. 1 - 1).
WARNING:
Always allow the power tool to cool down to room temperature be-
fore charging. This will extend the life of your battery.
3. The power indication lights (Fig. 1 - 2) indicate the power lever during charging.
Three lights means the tool is fully charged.
4. Upon full charge, disconnect the charger from the outlet, then disconnect the
charger from the tool.
ATTENTION:
A battery that has not been used for an extended period of time will have reduced battery capacity.
A substantial drop in operating period per charge indicates that the battery is worn out.
WARNING:
The charger and battery are specifically designed to be compatible. Do not attempt to use any other
devices to charge the battery or be charged by the charger. Never insert or allow metallic objects into the charger or
battery connections as an electrical failure and hazard may occur.
Fig. 1
1
2
Make sure all the following parts are accounted for before discarding the packaging.
If any part is missing or broken, contact our customer service at 1-800-232-1195.
9