CSA-PWS300/600-CAEN
Crestron Electronics, Inc.
Installation Guide – DOC. 7407A
15 Volvo Drive Rockleigh, NJ 07647
(2034068)
Tel: 888.CRESTRON
08.12
Fax: 201.767.7576
Specifications subject to
www.crestron.com
change without notice.
Introduction
The CSA-PWS300-CAEN and CSA-PWS600-CAEN are
wall-mounted power supplies that use one or two
C2N-SPWS300 power supplies.
The power supply provides regulated 24 volt DC, 300
Watt power to shade components. It operates with an
input of 100 to 240 VAC, 4 A (maximum) and a noise
rating of less than 150 mV. The power supply is capable
of delivering a nominal 75 Watts of power at 24 Volts
DC on any of its eight channels. Each channel is
accessed at the front panel of the unit via Cresnet
®
type
connectors. Outputs are limited to 75 Watts (3.125 Amps
typical) by an electronic circuit breaker. Each output
connector also has Cresenet Y-Z signals. All Cresnet
signals are parallel.
For simplicity within this guide, the term
“CSA-PWS300/600-CAEN” is used except where noted.
Functional Summary
CSA-PWS300/600-CAEN Specifications
(Continued in following column)
CSA-PWS300/600-CAEN Specifications (Continued)
SPECIFICATION
DETAILS
Controls
Power On,
Power Off,
Slave
(1) Rocker switch; selects
“SLAVE” mode to allow
enabling the power supply
system remotely by applying
an external 24V DC signal to
the
NET
port
Reset 1-8
(8) Miniature push buttons;
each resets its respective
output channel, or momentarily
disables the channel while
held
System Reset
(1) Miniature push button;
resets all output channels
sequentially, or momentarily
disables all channels while
held
Setup
Not used
LED Indicators
PWR 1-8
(8) Green LEDs, indicate
24 VDC power present at each
channel output
OVRLD 1-8
(8) Red LEDs indicate a load
in excess of 75 watts on a
given channel, channel output
disabled
SYSTEM
OVRLD
(1) Red LED, indicates a total
load in excess of 300 Watts on
the power supply system, all
channels disabled
PWR
(1) Green LED, indicates
power supply system is
enabled
NET
(1) Yellow LED, indicates
communication with Cresnet
network
SETUP
Not used
SPECIFICATION
DETAILS
Input Power
100 VAC to 240 VAC,
4 A, 50/60 Hz
Output Voltage
24 VDC (regulated)
Environmental
Installation Location
Indoor use only
Temperature
41º to 104º F
(5º to 40º C)
Humidity
10% to 90% RH
(non-condensing)
Weight
C2N-PWS300: 20 lbs
(9.1 kg)
C2N-PWS600: 25 lbs
(11.4 kg)
•
One (CSA-PWS300-CAEN) or two
(CSA-PWS600-CAEN) 24 Volt, 300 Watt
Cresnet power supplies
•
Eight output channels per power supply (each
with 75 W rating) monitored and controlled by a
Cresnet port
•
Power switch allows for single-point shutdown
•
Ventilated cover for convection cooling of
modules encased in enclosure
•
Conveniently located electrical knockouts for
both Class 1 and Class 2 wiring
•
16 gauge hot dipped galvanized steel enclosure
