Power Supply for Crestron
®
Shades
Crestron
CSA-PWS300/600-CAEN
Installation Guide – DOC. 7407A
Power Supply for Crestron
®
Shades: CSA-PWS300/600-CAEN
•
9
NOTE:
All Crestron certified Cresnet wiring must consist of two twisted pairs. One
twisted pair is the +24V conductor and the GND conductor and the other twisted
pair is the Y conductor and the Z conductor.
Strip and Tin Wire
Strip the ends of the power supply wires carefully to avoid nicking the conductors.
Twist together the ends of the wires that share a pin on the network connector and tin
the twisted connection. Apply solder only to the ends of the twisted wires. Avoid
tinning too far up the wires or the end becomes brittle. Insert the tinned connection
into the connector and tighten the retaining screw. Repeat the procedure for the other
three conductors.
Add Hubs
Use of a Cresnet Hub/Repeater (CNXHUB) is advised whenever the number of
Cresnet devices on a network exceeds 20 or when the combined total length of
Cresnet cable exceeds 3000 feet (914 meters).
Further Inquiries
To locate specific information or resolve questions after reviewing this guide, contact Crestron's True Blue Support at
1-888-CRESTRON [1-888-273-7876] or refer to the listing of Crestron worldwide offices on the Crestron Web site
) for assistance within a particular geographic region.
To post a question about Crestron products, log onto the Online Help section of the Crestron Web site
). First-time users must establish a user account to fully benefit from all available features.
Future Updates
As Crestron improves functions, adds new features and extends the capabilities of the CSA-PWS300-CAEN and
CSA-PWS600-CAEN additional information may be made available as manual updates. These updates are solely electronic
and serve as intermediary supplements prior to the release of a complete technical documentation revision.
Check the Crestron Web site periodically for manual update availability and its relevance. Updates are identified as an
“Addendum” in the Download column.
