19
18
ROUTINE INSPECTION
Before each use, inspect the general condition of the
tool. If any of these following conditions exist, do not
use until parts are replaced or the saw is properly re-
paired.
Check for:
• Loose hardware,
• Misalignment or binding of moving parts,
• Damaged cord/electrical wiring,
• Cracked or broken parts, and
• Any other condition that may affect its safe operation.
CLEANING & STORAGE
1. Keep the ventilation openings free from dust and
debris to prevent the motor from overheating. NOTE:
Always use a dust collection system. This will help pre-
vent sawdust from building up inside the band saw.
2. Wipe the tool surfaces clean with a clean cloth. Make
sure water does not get into the tool. Remove any pitch,
sap, or resin that has accumulated on the table, blade
guide, bearings, etc. using a damp cloth.
MAINTENANCE
WARNING! To avoid accidents, turn OFF and unplug the tool from the electrical outlet before cleaning,
adjusting, or performing any maintenance work.
WARNING! Any attempt to repair or replace electrical parts on this tool may be hazardous. Servicing of the
tool must be performed by a qualified technician. When servicing, use only identical WEN replacement parts.
Use of other parts may be hazardous or induce product failure.
CAUTION! Most plastics are susceptible to dam-
age from various types of commercial solvents. Do
not use any solvents or cleaning products that could
damage the plastic parts. Some of these include but
are not limited to: gasoline, carbon tetrachloride,
chlorinated cleaning solvents, and household deter-
gents that contain ammonia.
4. At least once a month, check the V-belt for proper
tension and any signs of wear.
5. Store the tool in a clean and dry place away from the
reach of children. Store in temperatures between 41° to
86°F.
6. Cover the band saw in order to protect it from dust
and moisture. Keep the instruction manual and all ac-
cessories nearby.
7. If you do not plan to use the band saw for a long pe-
riod of time (over 1 week), release tension on the blade.
This will help prolong blade life.
LUBRICATION
1. As needed, apply a light coat of good-quality paste
wax to the table. This will help provide a smooth gliding
surface for your workpieces.
2. As needed, apply a light coat of dry lubricant (PTFE
works well) to the space between the table bevel brack-
ets and the base bracket. This will help ensure that the
table bevels easily.
3. The bearings on your band saw are permanently
sealed and lubricated, and require no additional lubrica-
tion.
PRODUCT DISPOSAL
Used power tools should not be disposed of together
with household waste. This product contains electronic
components that should be recycled. Please take this
product to your local recycling facility for responsible
disposal and to minimize its environmental impact.
Please recycle the packaging and electronic
components where facilities exist.
3. At least once a month, open the doors and vacuum
out any accumulated dust, shavings, etc. Remove the
blade and clean off any built-up sawdust from the
wheels and tires using a stiff brush.