22
Operating instructions (continued)
Avoiding kickback
The Table Saw can be used for straight-line cutting, such as cross cutting, ripping, mitering,
beveling and compound cutting. However, kickback can occur when the Blade stalls, a cut is
made at an incorrect depth, or you saw into a knot or nail. To avoid kickback, do the following:
1.
Use the correct blade depth setting. The top blade teeth should clear the workpiece by
1/8”to ¼”.
2.
Inspect the workpiece for knots or nails before beginning a cut. Knock out any loose knots
with a hammer and do not saw into loose knot or nail.
3.
Use the Fence when rip cutting and the Miter Gauge when cross-cutting.
4.
Use clean, sharp and properly-set blades. Do not use dull blades.
5.
Support the workpiece properly to avoid pinching.
6.
When making a cut, use steady and even pressure. Do not force cuts.
7.
Do not cut wet or warped lumber.
8.
Hold the workpiece firmly with both hands or use the included Push Stick (53). Make sure
the Push Stick is narrower than the workpiece and has 90º notch on one end and shaping for
a grip on the other end.
9.
A push block (not included) can be used with non-through cuts.
CAUTION:
Make sure the push block’s screws are recessed before using on Table Saw.
Making a cross-cut
WARNING!
Using the Fence as a cutoff gauge when cross-cutting will result in kickback,
which can lead to serious injury and property damage.
Remove the Fence.
Turn the Handwheel counterclockwise until the Blade is set at the correct depth for the
workpiece.
Set the Miter Gauge at the desired angle and lock into place using the lock Knob.