17
Operating instructions
Read the general instructions and safety rules section at the beginning of this manual
before set up or use of this product.
Table saw adjustments
To prevent serious injury from accidental operation:
Turn the Power Switch of the tool to its “OFF” position, remove Safety key, and
unplug the tool from its electrical outlet before performing any inspection,
maintenance, or cleaning procedures.
WARNING!
Check the Blade Guard assembly before and after every use.
Blade depth and angle adjustments
The Blade (96) depth should be set so that outer points of the Blade are 1/8” to ¼” higher than
the workpiece while the lowest points are below the workpiece.
To raise the Blade, turn the Handwheel (29) counterclockwise.
To lower the Blade, turn the Handwheel clockwise.
To adjust the Blade’s angle, loosen the Bevel Lock Knob (62) and then turn the Handwheel
until the Blade reaches the desired angle. Then tighten the Bevel Lock Knob. See below.
When the Blade is tilted to the left as far as it will go, the Blade should be at a 45º angle to the
Saw Table and the Bevel Indicator on the Ruler (13) should point to 45º.