![background image](http://html1.mh-extra.com/html/wen/23190/23190_manual_956424005.webp)
15. DO NOT OVERREACH. Keep proper footing and balance at all times. Wear oil-resistant rubber-soled foot-
wear. Keep the floor clear of oil, scrap, and other debris.
16. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order. Follow instruc-
tions for lubricating and changing accessories.
17. CHECK FOR DAMAGED PARTS. Check for alignment of moving parts, jamming, breakage, improper
mounting, or any other conditions that may affect the tool’s operation. Any part that is damaged should be properly
repaired or replaced before use.
18. MAKE THE WORKSHOP CHILDPROOF. Use padlocks and master switches and ALWAYS remove start-
er keys.
19. DO NOT operate the tool if you are under the influence of drugs, alcohol, or medication that may affect your
ability to properly use the tool.
20. USE SAFETY GOGGLES AT ALL TIMES that comply with ANSI Z87.1. Normal safety glasses only have
impact resistant lenses and are not designed for safety. Wear a face or dust mask when working in a dusty environ-
ment. Use ear protection such as plugs or muffs during extended periods of operation.
GENERAL SAFETY RULES
ROTARY TOOL SAFETY RULES
1. CHECK THE WORKPIECE for any cracks, bumps, nails or obstructions before commencing operation.
2. NEVER press in the collet lock button when the rotary tool is running.
3. DO NOT cut any workpiece larger than the rotary tool’s capacity. Always maintain a firm grip on the rotary tool.
4. SECURE THE WORKPIECE whenever possible to prevent wobble, damage to the workpiece, and personal
injury.
5. ALWAYS USE safety goggles, a dust mask and hearing protection when using the rotary tool.
6. BEFORE TURNING ON THE ROTARY TOOL, ensure that it is completely clear of the workpiece.
7. NEVER touch any moving parts of the tool by hand.
8. CHECK THE POSITION of all electrical wiring and plumbing equipment when drilling into walls, floors or
ceilings.
9. DO NOT remove the attachment from the tool until it has completely stopped rotating.
10. DO NOT touch the attachment after operation, as it may be very hot. Allow time for the attachment to cool
before removing it.
11. DO NOT operate the tool in wet or damp conditions. Doing so significantly increases the risk of electrical shock
and other hazards.
12. DO NOT USE the tool if the ON/OFF switch is faulty, the plug or cable is damaged, or the tool produces
sparks, smoke, or unpleasant odors.
5