46
7-1 FXO line
Figure 7-1 FXO setting
User ID:
FXO Line number (1 to 8).
User Type:
the line type which is FXO.
The line type is either FXO or
FXS. If this RJ-11 connector color is Grey, then it is a FXO port and here
should be showed as FXO.
Line State:
Set up active if you would like to use this line. Otherwise,
set to Inactive.
TEL NO:
This field can be used as a reference remark for this line.
Normally, you can put the connected PSTN line’s phone number here
for reference.
Polarity Reversal Detection:
When enable the Polarity Reversal
Detection; the Wellgate 2880 will use the polarity reversal signal as the
answer signal for FXO outgoing call. When disable the polarity Reversal
Detection, the Wellgate 2880 will use Dialing Answer Delay Time for
answering the SIP call.
Current Drop for disconnect (CPC):
Use Line current drop as a
disconnect supervision or not.
Incoming call handling:
The call handling policy for a FXO incoming
call.
Hot line TEL:
When a FXO incoming call was detected and after
the PSTN Answer Ring Count, Wellgate 2880 will send the SIP
call to the specified hot line TEL number through the Route Plan.