F1 20A 250V
J29
J23
OZONE
PUMP 1
K4
K1
Neutral - White or Blue conductor
Not used
Line - Black or Brown conductor
Not used
Empty
Black or Brown Line Conductor
Balboa Ozone connector configuration for 230VAC 50Hz:
L
N
Empty
White or Blue Neutral Conductor
Flat sides of sockets as shown
Ozone Connections
Ozone Connections
Ozone Connector Voltage:
The VS100 circuit board is factory configured to deliver a preset voltage of 120V to
the on-board ozone connector (J29).
Balboa Ozone Generator:
The board is set up to operate a 120V ozone generator; the connector on the ozone
generator is likely to be configured correctly, but should be compared to the illustration below.
Note: A special tool is required to remove the pins from the connector body once they are snapped in place.
Check with your Balboa Account Manager for information on purchasing a pin-removal tool.
