Using Webconsole, you can change the protocol of the modem to PPPoA Bridged mode
by clicking on “Config/PPPoA Bridged”
For setting as PPPoA bridged, you
need to have the information for
VPI(Virtual Path
Identifier)/VCI(Virtual Channel
Identifier) from ISP.
The range of VPI value is from 0 to
4095,
and the range of VCI value is from 1
to 65535.
As well, you need to select a proper Data Encapsulation Method.
To set the Bridge Port on the WAN, User ID and Password for authentication are given
from the ISP.
You can select a proper authentication method.
3 . 2 . 5 P P P o E R o u t e d M o d e ( R F C 2 5 1 6 / N o u s i n g P P P c l i e n t S / W )
Here is an example of setup for PPPoE routed mode(No using PPP client S/W)
If set up is as follows,
PC Side
subnet1: 192.168.1.0
netmask: 255.255.255.0
gateway: 192.168.1.1
Using CLI(Command Line Interface), you can change the protocol of the modem to
PPPoE Route mode by the following steps.
At the Terminal Console Screen:
Remove all of the existing module devices
> c o n f i g r e s e t b r i d g e
> i p d e v i c e f l u s h
> c o n f i g r e s e t p p p
> c o n f i g s a v e
Saving configuration...Configuration saved.
