Wellcraft 180 Sportsman, Owner'S Manual

Page: 29 / 92

Note: Some fuel injected engines have fuel
filters on the engine and do not allow
external filters. If your boat is equipped
with a fuel injected engine, it may not
have a separate water separator fuel filter.
3.3 Fueling Instructions
To fill the fuel tank at a marina, follow this procedure:
1. Make sure all switches are in the “OFF” position.
2.
Make sure the boat is securely moored.
3.
Make sure all passengers leave the boat.
4.
Estimate how much fuel is needed and avoid over
filling.
5.
A special key to open the fuel cap is supplied. Turn
the key counterclockwise to open the cap.
6.
Remove the cap.
7.
Put the nozzle in the fuel opening.
9.
Fill the fuel tanks slightly less than the rated
capacity to allow for expansion and to avoid spilling
fuel out of the vents and fuel fills.
10.
Remove the nozzle.
11.
Install and tighten the fuel cap. Be careful not to
over-tighten the cap.
12.
Check the fuel compartment and below the deck for
fuel odors. If you smell fuel, do not start the
engine.
3.4 Fuel System Maintenance
Periodically inspect all connections, clamps and hoses
for leakage and damage or deterioration. Replace as
necessary. Spray the valves, fuel tank gauge sender
and ground connections with a metal protectant.
Frequently inspect and lubricate the fuel fill cap O-ring
seals with petroleum jelly or silicone grease. The O-
ring seal prevents water from entering the fuel system
through the fuel fill cap and it should be replaced
immediately if there is any sign of damage or
deterioration.
29