Wellav Contura, Instruction Manual

Page: 30 / 132

ENGLISH
30
Oiling the blade head
To maintain the high-quality cutting performance of
the blade head as long as possible, it must be oiled
regularly –
preferably daily .
– Remove the comb attachment
if fitted.
– Oil the positions where the
top and bottom cutting blades
meet (see also the figure on
the left).
Replacing the blade head
The blade head is subject to wear. Even if you look
after the appliance properly, the cutting perform-
ance will deteriorate. Replace the blade head when
it is worn. The blade head can be ordered separate-
ly as a spare part from Wella Customer Service.
– Make sure the On/Off switch
4
is in the 0 position.
– Remove the Allen key 13 from
the base of the charging unit
and use it to loosen the blade
head screw
6.
– Loosen the screw fully and
remove it.
– Push the blade head upwards
with your thumb.
– Push the new blade head on
until it snaps into place and
secure it using the screw.
While the blade head is removed, you can use the
cleaning brush 12 to remove residual hair carefully
from inside the appliance.
Cleaning the appliance
– Clean your appliance occasionally with a damp
cloth, then wipe it dry.
Contura.book Seite 30 Freitag, 6. Januar 2012 1:01 13