IOM-080
Last Updated: 10/20/2014
PART #: HBAWEL9 & HBAWEL15
Page 5 of 7
Rev: C
Section 2:
INSTALLATION & OPERATION
1.
Wrap the heat blanket around the equipment.
2.
Secure the heat blanket to the equipment using the loop and hook closures.
3.
Close the Velcro
®
seams.
4.
If a thermostat is not included, connect the blanket cable directly to the power source.
5.
If a thermostat is included, open a small section of the heat blanket seam, and then insert the
thermostat sensor so that the thermostat sensor is between the heat blanket and the equipment.
Secure the Velcro
®
seam around the thermostat sensor to minimize heat loss.
6.
If a thermostat is included, make the terminations from the heat blanket cable to the terminal
strip of the thermostat, and then make the terminations from the terminal strip of the thermostat
to the power source.
7.
Turn ON the power source. As necessary, adjust the thermostat to the desired temperature.
8.
The blanket is now in operation.
After unpacking the unit, check the equipment for compliance and for any damage that
may have occurred during shipment.
Claims for damage caused during shipment
must be initiated by the receiver and directed to the shipping carrier.
Welker
®
is
not responsible for any damage caused by mishandling by the shipping carrier.
When sealing fittings with PTFE tape, refer to the proper sealing instructions for the
tape used.
Electrical terminations should only be installed by a qualified electrician.
Conduit seals are provided for the cable and power source connections when a
thermostat is included.
