WELGER RP 202 • RP 220 • RP 302 • RP 320
65
11.1. Your Safety
The "Balercontrol" control system was designed and
manufactured with utmost attention to details and maximum
precision. Each unit has been checked and tested for correct
functioning before delivery. Despite all the precautions, a
malfunction can still occur. Therefore, the "Balercontrol" control
system and associated baler should be always operated in such
a manner that prevents damage to person or property.
Never carry out adjustments, repairs, maintenance and service
work on the "Balercontrol" while the machinery is running.
Always first stop the pto shaft and detach the universal drive
shaft from the power take off stub before working on the baler or
near moving baler components.
A safety clearance from the machine must be maintained during
baler control diagnosis.
11.2. Protection of the electronic control system
•
All assembly and maintenance work (connection and
disconnection of sensors, valves, control panels etc.,
replacing of fuses) must be carried out with the power supply
disconnected.
•
"Balercontrol" is designed to operate with a 12 volt power
supply. The system must not be connected to other on-board
power supplies!
•
The "Balercontrol" control panel should at all time be in a
position where it is protected from water spray (tractor cab or
the baler twine compartment, with the cable outlet pointing
downwards).
•
When welding on the baler:
-
Do not allow the welding current to pass through the
control unit.
-
Disconnect the power supply between the tractor and
baler.
-
Be careful of heat generated at welding points; detach
any potentially sensitive components (cables, sensors
etc) before welding.