8
Accessories
• Only WELDY accessories must be used:
Article: Fuse 4A
10 pcs.
Article: Fuse 1A
10 pcs.
Article: Screwdriver
2 pcs.
Article: Inner hexagonal spanner
2 pcs.
Article: Silica gel wheel
1 pair
Article: Hot wedge (spare part)
1 pc.
Maintenance, Service and Repairs
• The complete machine should be cleaned, greased and placed in a dry place if it is not used.
• For PVC welding, the adhesions on hot wedge should be cleaned off if it is not used longer than 4 hours
to prevent wedge corrosion and service life being shortened.
• Recommended: For welding of material that corrosive gas may be produced after hot fusing such as PVC
and the like, stainless steel hot wedge (optional accessory) is preferred for extending of service life.
• Repairs should only be carried out by Weldy-partners. Restricted to use with original Weldy accessories
and spare parts.
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case of
guarantee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced
by the distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery
document. Hot wedge shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
Troubleshooting
Hot wedge do
not heat
Tubular electric heating element damaged
Replace hot wedge assembly
Thermocouple failure
Replace thermocouple
Temperature control knob loosened
Tighten temperature control knob
Temperature control circuit board damaged
Replace temperature control circuit board
or control box assembly
Hot wedge is
burned red
Thermocouple failure
Replace thermocouple
Controlled silicon disruption
Replace controlled silicon or control box assembly
Chain
jumping
There may be sand or small stones on
chain and gear
Remove sand or small stones
