Weldy Iberian booster EX2, Operating Manual

Page: 8 / 48

8
Blank V Seam Fillet
weld
Overlap
seam
Corner
seam
outside
Corner
seam
short
Corner
seam
long
Accessories
Maintenance
Service and Repairs
Warranty
• Only WELDY accessories must be used.
• WELDY offers the right welding shoes for different common types of seam:
• In case of soiling clean the air inlet on the hot air blower with a brush.
• Clean the
extruder nozzle (19) each time the welding shoe is replaced and remove any welding deposits.
• Check power supply cord and plug for electrical and mechanical damage.
• Regularly clean the air hose.
• Ensure the carbon brushes of the drive and hot air blower checked by your service center after 100 hours
of operation. The drive and the hot air blower switch off automatically once the minimum carbon length
has been reached.
• Repairs should only be carried out by Weldy-partners. Restricted to use with original Weldy accessories
and spare parts.
• For this tool, the guarantee or warranty rights granted by the Weldy-partners shall apply. In case of guaran-
tee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced by the
Weldy-partners at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery
document. Heating elements shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper hand-
ling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
Replacement of carbon brushes (drill machine)
1. Unscrew the carbon brush cap.
2.
Take out the carbon brush.
3.
Put on the new carbon brush and screw cap on.
1.1 1.2 2 3.1 3.2
Switch off the hot tool and disconnect it
from the mains supply.