WeldKing COOLARC 200, Owner'S Manual

Page: 19 / 38

Page 14 Manual no. WM070401
4-4. General installation procedure for Lift-TIG welding
4-4.1.Welding machine should be installed in a stable position and with good ventilation. Avoid
direct sun outdoors or rain. Place at a distance of 12” (300mm) or more from walls or similar
that could restrict natural air flow for cooling. Avoid transport in invert or side position.
4-4.2.Switch the ON/OFF Switch (located on the rear panel) to OFF.
4-4.3.Connect electrode holder, earth cable, according to connection diagram (refer to Figure 4.3
and 4.4). Insert Electrode holder/earth clamp quick connector into receptacle and turn 90º
clockwise.
4-5. Electric service guide
CAUTION!
WARNING: THIS WELDING MACHINE MUST BE CONNECTED TO POWER SOURCE IN
ACCORDANCE WITH APPLICABLE ELECTRICAL CODES
AVERTISSEMENT: LE RACCORDEMENT DE CETTE MACHINE DE SOUDAGE Á
L’ALIMENTATION DOIT ÉTRE CONFORME AUX CODES D’ ÉLECTRICITÉ PERTINENTS
Input voltage(V) 115 208/230
Frequency(Hz) 60 60
Input Amperes at rated
output(A)
20 32
Max recommended
standard fuse Rating in
Amp
Circuit breaker, time delay
Normal operation
20
20
40
55
Min input conductor size in
AWG
11 11
Min Grounding conductor
Size in AWG
5 5
Table 4.1