Day & Night 10X Zoom Camera
10
u
TELE Key Button
Press TELE (Telephoto) to zoom in.
This button is used for UP in the menu mode.
w
ADJUSTMENT Key Button
User preset 3, 4 value displays repeatly when pressing Adjustment key.
When it is User preset 3 statue, RED LED is ON and when it is suer preset 4 statue, LED is OFF.
Used user preset 3 for special purpose of night mode. Used preset 4 for break up mode.
x
WIDE Key Button
Press WIDE (Wide ange) to zoom out.
This button is used for DOWN in the menu mode.
Intermediate End monitor
6.0 Connection
6.1 Connecting to Monitor
Connect the VIDEO-OUT jack to the VIDEO-IN jack of monitor.
q
As the connecting method varies with the instruments,
refer to the manual supplied with the instrument.
q
If necessary, you can connect the monitor to the REMOTE jack on the back of your camera.
q
Only connect the cable when the power is turned off.
q
Set the 75 Ohm / Hi-Z selection switch as shown below if you have an intermediate device.
6.2 Connecting to Power
Connect the adaptor to the power input connector as shown in the figure below.
The recommended adaptor specification for WDN-1003XP is DC 12V / 500mA.
q
Standard voltage for camera operation : DC 12V + 10%
q
There may be some deviation in voltage drop depending on the type of wire
and the manufacturer.
Day & Night 10X Zoom Camera
11
Monitor
Adapter
485 CONTROL BOARD CONNECTION TERMINAL
(+)CONNECTION TERMINAL
(-)CONNECTION TERMINAL
RS-485 CONTROL CABLE
RED (TRX+)
WHITE(TRX-)
Note
l
When you construct external control systems for a camera control, please use to the PELCO-D PROTOCOL.
l
When you connecting to RS-485 control cable, please peel off the outer skin inside the RS-485 control cable.
6.3 RS-485 Communication Control
Using a RS-485 communication, it will be able to control the ZOOM/FOCUS and OSD menu at the Controller or DVR.
q
The case which it controls from the PC Using a RS-485 converter, It connects to RS-485 control cable outside camera and serial cable.
EX) SERIAL PORT OF THE PC(COM1) -- SERIAL CABLE -- RS-485 CONVERTER -- RS-485 CONTROL CABLE
q
The case which it controls from the DVR or System Controller .
It connects the RS-485 control cable in the connection terminal of 485 control boards which are connected with the DVR or
System Controller.
Day & Night 10X Zoom Camera
12
RED (TRX+): RS-485 +
WHITE (TRX-): RS-485 -
