Welch Allyn Scanteam 2010 wedge, User Manual

Page: 119 / 134

9–3 SCANTEAM 2010 User’s Guide
Does the decoder read your bar code incorrectly?
If the decoder reads a bar code ( one beep for a good read ), but the bar
code is not displayed correctly on the host screen:
➊ The decoder may not be programmed for the appropriate terminal
interface.
You scan 12345" and the host displays @es%."
Reprogram the decoder with the correct Plug and Play" or Terminal
Selection bar code ( see Section 2, QuickStart Menu ).
➋ The decoder may not be programmed to output your bar code
properly.
You scan 12345" and the host displays A12345B."
Reprogram the decoder with the proper Symbology selections ( see
Section 5, Symbology Menu ).
The decoder won’t read your bar code at all?
If the decoder will not read your bar code:
➊ Try scanning the Sample Bar Codes ( found near the end of the User's
Guide ).
If the decoder reads the Sample Bar Codes, check that your bar code
is readable. ( See Is the decoder having trouble reading your bar
codes" on the previous page. )
If the decoder does not read the Sample Bar Codes either, continue
to #2, below...
➋ If the decoder won't read the Sample Bar Codes either:
Verify that the bar code symbologies are enabled. (
See Sections 5,
Symbology Menu. )
Verify that your bar code symbology is enabled. ( See Sections 5,
Symbology Menu. )
Scan the Default All... " bar code on each symbology menu page in
Section 5 to enable most symbologies. ( MSI and Plessey will have to
be enabled individually, as they are defaulted . )