Service Manual
Repair Procedures
59
4.
Remove the battery.
5.
Verify that the neon bulbs are vertical, so that they are not crushed between the front
and rear cases during reassembly.
6.
Screw the rear case to the front case, making sure the rubber gasket stays in its
groove. Torque the screws as shown in the illustration below.
7.
Push the rubber feet into the rear case. For ease of installation, apply a small amount
of alcohol to the rubber feet.
Note
Use all new screws, label covers and rubber feet (supplied in the service fastener
kit) when reassembling the case.
Two pan-head screws, 2-56 x 3/16.
Torque to 3 in. lbs.
Four pan-head screws, 4-40 x 3/8.
Torque to 5 in. lbs.
