20
ATTENTION - IMPORTANT INFORMATION
concerning the “Cleaning” warning indicator:
If, after several temperature measurements, the
device's green backlighting starts to flash for
approx. 1 minute with acoustic signal output, this
is
not a malfunction
,
but the “Cleaning”
warning indicator
! In this respect, please read
section
17.0
on page 37! If this warning indicator
is not switched off by pressing the
MEM
button,
this indicator will occur every time you try to per-
form a measurement and will disable subsequent
temperature measurements!
PLEASE NOTE:
If
“Lo”
or
“Hi”
are shown on the
display after a measurement has been performed,
the permissible measuring range was fallen short
of or exceeded during the measurement.
PLEASE NOTE:
If you wish to immediately return
to the standby mode from the setting or the
memory mode, you must simultaneously press
the
( )
“Ear measurement” and
( )
“Forehead
measurement” buttons. The device, however, also
switches to the standby mode if,
you do not press any
button within a period of approx. 1 minute or if, in
the setting or the memory mode,
within a period of approx. 30 seconds.
after a measure-
ment has been carried out,
you do not press
any button
if you hold the device in such a manner that the
front side with the buttons is facing the user. In
the temperature measurement mode and in the
memory mode, it is the other way round: In this
case, the display is in the correct position if you
hold the device in such a manner that the rear
side is facing the user.
BASIC FUNCTIONS
D
USA
19.PJN174-14_GA-USA_HHD-Ohrthermometer_DSO364_28.07.14
Montag, 28. Juli 2014 14:37:39
