Merrychef eikon
®
e2s service and repair manual
84
_______________________________________________________________________________________________________________________________
_______________________________________________________________________________________________________________________________
6 Replacing components
Back to contents >
Fitting the stirrer motor and assembly
Follow the steps in the reverse order to fit the stirrer motor.
IMPORTANT:
Follow the steps in the reverse order to fit the stirrer.
When refitting the partition plate fasten the screws on opposite corners/sides in turns and do NOT proceed
stringently clockwise or anti-clockwise.
Tighten the partition plate screws to 2.1 Nm of torque.
Tighten the jet/impinger plate screws to NO more than 1.8 Nm of torque.
4.
Remove the partition plate from the cavity.
NOTE: The partition plate features a rubber
gasket on the side pointing upwards (to the
stirrer) when mounted. The rubber gasket
prevents grease laden air from soiling the
stirrers and needs to be intact at any time.
5.
The image shows the 1000W e2s variant equipped with one stirrer/stirrer motor.
The 2000W e2s variant has a second stirrer/stirrer motor in the right niche.
The stirrer(s) is positioned inside the top of the oven cavity, above the partition
plate.
7.
To remove the stirrer
from the spindle, the
motor must be prevented
from moving. This is most
easily achieved by holding
the stirrer cog located
next to the motor cog.
8.
The stirrer can then be removed by turning anti-clockwise.
9.
Remove any remains of the old gasket from the top of the cavity
before fitting a new partition plate (comes with gasket) to ensure a
good seal.
