Merrychef eikon
®
e2s service and repair manual
60
_______________________________________________________________________________________________________________________________
_______________________________________________________________________________________________________________________________
5 Service information
Back to contents >
2.
Take protective measures to ensure the power cannot be switched on again.
3.
Allow the appliance to cool down.
4.
Remove the side and top panels of the casing.
5.
Check the cavity temperature sensor wire and connections.
6.
If the wire and connections are correct and in good condition, replace the cavity temperature sensor (see Section
6.16. – Overview - further components).
7.
Refit the panels of the casing.
8.
Switch ON the appliance and repeat the test procedure as described above.
9.
If the temperature is still unstable repeat steps to make safe and replace the SRB (see Section 6.9 Replacing the
SRB).
10.
Refit the panels of the casing.
11.
Switch ON the appliance and repeat the test procedure as described above.
5.7
Recommissioning test
Recommission test:
Recommissioning the appliance after service/repair has been completed on all service calls
The recommission tests are performed following the completion of a service or repair to ensure that the appliance is working
correctly before handing back to the customer.
Some of the tests have a countdown timer, where failing to carry out a test within the time limit will cause a test failure and
the recommission test will have to be restarted.
If the ‘recommission test’ tab is greyed out, the oven is above 200°C and will not allow to the test to commence until the oven
is cooled down.
Note: If the door is opened during the 12 second microwave circuit test, or the 19 second heater circuit test, the test will stop
and reset the timer, commencing again once the door is closed.
1.
Select ‘recommission test’ from the Service Mode oven tests
and follow the on screen instructions to perform the tests.
Do not select the red ‘X’ unless you want to stop the test.
The test will check in the following order;
§
Door switch operation
§
Filter switch operation
§
Microwave circuits
§
Heater circuit
§
Convection fan operation
§
Cooling fan operation
The test will stop at any point a failure is detected.
2.
After a test has successfully
passed, select the green check mark
to continue.
3.
When all the tests have been
successfully performed the display
shows the recommission test has
passed. Select the green check mark
to confirm.
4.
In the event of a recommission
test failure, the detail will be
recorded in the Error Log.
Rectify any error and repeat the
recommission test.
