15
Microwave instruction manual – Model:
microMD UK
/
m
i
c
r
o
MD Euro
The front filter serves as the air inlet;
the filter should be cleaned regularly
to keep the cavity clean.
1. Turn counter clockwise to unscrew and
remove the filter and wash it with warm soapy
water.
2. To install the filter screen, tighten the screws
clockwise to secure the filter.
3. Ensure the filter is installed before use of the
microwave oven.
4. The factory setting has the function to remind
the user of washing the filter every 30 days.
Splash shield cleaning
1
.
Detaching:
Hold the two buckle positions in
front of the splash shield (as shown above
by the arrows). Apply your strength in the
direction of the arrows and
pull downwards after you have pulled out
the buckles.
2
. Wash the splash shield.
3
.
Installation:
Pick up the splash shield and put
it into the cavity in the way that it was originally
inserted, at the rear, into the positioning hole
on the rear plate of cavity. Then push the other
side to insert all positioning pins are in their
positioning holes.
Installation (supplement)
1. The switching operation of this microwave
oven can cause voltage fluctuations on
the supply line. The operation of this
oven, under unfavourable voltage supply
conditions, can have adverse effects. This
device is intended for the connection to
a power supply system with a maximum
permissible system impedance Zmax of
0.3 Ohms
at the interface point of the
user’s supply. The user has to ensure that
this device is connected only to a power
supply system which fulfils the requirement
above. If necessary, the user can ask their
public power supply company for the
system impedance at the interface point.
2
. If there is no equipotential bonding
conductor in the electric supply, an external
equipotential bonding conductor must be
installed at the rear of the appliance
(see symbol below). This terminal shall
be in effective electrical contact with all
fixed exposed metal parts and shall allow
the connection of a conductor having a
nominal cross-sectional area up to 10 mm
2
.
Symbol for the external
connection of equipotential
bonding conductors.
Filter
Caution!
Make sure the splash shield is installed
correctly before using the microwave oven.
Filter screws
Filter cleaning
