Warning!
General information
The BiSens SW-230V is a combined light/wind/radio control device
for your awning and venetian blinds.
Important!
The BiSens SW-230V works only in connection with radio receivers
of the weinor radio system BiConnect and Weitronic.
Radio signals (frequency 868.3 MHz) are transmitted between the
BiSens SW-230V and the receiver. Power supply is via connection
to the mains network.
Recommendation:
Use a weinor manual/automatic sliding switch
to deactivate the light function.
Safety instructions
Warning!
Danger of injury from electric shock.
• Connections must be performed by an authorised
specialist.
80
200
135
35
66
10
12
14
2
Off
8
4
6
11
1
3
9
5
7
Funktion
yellow LED
(light value)
red LED
(Wind value)
green LED
(transmit)
DOWN
button
(Sun
symbol)
UP
button
(Wind symbol)
Function
position
Connection
1. Remove the wall fixing screws (b) of the BiSens SW-230V.
2. Remove the cover.
3. Connect the BiSens SW-230V.
4. Replace the cover on the device.
5. Screw on the cover.
b
L
N
Electrical connection of the BiSens SW-230V
1. Switch off the mains supply.
2. Connect the cables to the BiSens SW-230V according to colour:
blue = N
black = L
3. Switch on the mains voltage.
Connect at least a 2-core cable (UV resistant
0.75 - 1,5mm²) to terminals L and N of your
BiSens SW-230V. The connection of the pro-
tective earth is not necessary.
Note:
Horizontal mounting position.
Light sensor top, wind sen-
sor underneath
Important safety notes!
Observe the following instructions.
• Only use unmodified original weinor parts.
• Keep persons away from the system's operating
range.
• Keep children away from the control units.
• Comply with the regulations in your country.
• The system's operating range must be kept in
view during operation if one or more units are
available for controlling the system.
• The unit contains small parts which could be
swallowed.
• Radio systems transmitting on the same frequen-
cy can interfere with the unit.
• Note that the range of the radio signal is limited
by legislation and adjacent walls and buildings.
181228806_EN_0214
80
Note:
The housing may show condensation water.
Intended use
The BiSens SW-230V must
only be used for controlling
awnings,
roller shutters and venetian blind installations.
Third-party devices should only be connected after consultation with
your specialised dealer.
• Please ensure that the radio systems are not operated in areas
where interference is a hazard.
(e.g. hospitals, airports. . .).
• The remote control is only approved for units and systems for which
any malfunction of the hand-held transmitter or receiver would not
result in a risk to persons, animals or property, or if such a risk is
covered by other safety devices.
• The operator does not benefit from any protection whatsoever
against interference from other remote control equipment and ter-
minal equipment (e.g. also from radio equipment which is correctly
operated in the same frequency range).
• Only use radio receivers with equipment and systems approved by
the manufacturer.
BiSens SW-230V
STOP/P
button
Original installation manual