Weidmuller SpeedMarking-Laser, User Manual

Page: 26 / 36

Troubleshooting
26 5658600000/00/05.07
6.5 Checklist for troubleshoot-
ing
If the SpeedMarking-Laser is not printing, follow the
checklist in its specified order.
Make sure that the ready LED lights up.
If no LED lights up:
•
Check the connection of the mains cable.
•
Check the on/off switch.
•
Check the power source.
•
Check the fuses.
You can find more information in chapter
6.1 "Fuses".
6.5.1 Troubleshooting for error mes-
sages
If the error LED lights up, there is an error at the
SpeedMarking-Laser.
Find the corresponding LED display and follow the
solution suggestions to remedy the error.
Repairable errors
•
The upper cover is open. Close the upper cover.
•
The toner cartridge is missing or has not been in-
stalled properly. Check the toner cartridge and
place it carefully into its right position.
•
Accumulated material is in the SpeedMarking-
Laser.
Refer chapter 6.3 "Remedy for ".
Data error
If the error LED and the data LED light up simulta-
neously, a data error has occurred at the Speed-
Marking-Laser.
•
To find out the reason for the data error, press the
buttons Test and Job Cancel and keep these
pressed. A second LED display indicates the par-
ticular error.
EA error
The connection cable between the printer and com-
puter is possibly loose or of low quality.
•
Make sure that the cable is fixed strongly and that
you use a high-quality cable.
Errors, when the printing can be continued
A temporary error occurred during printing.
•
Press the key Test . The page will automatically be
printed again.
Temporary error
The printer has a temporary error.
•
Turn the SpeedMarking-Laser off and on again. If
the error occurs again, contact the customer sup-
port. Phone 49 (0) 52 31 14 12 52.