17
41. Wrap the Leg Lever Cable (70) under a 90mm
Pulley (39). Attach the Pulley and two Half Finger
Guards (42) to the Right Base (1) with an M10 x
45mm Bolt (101) and an M10 Nylon Locknut
(114).
Make sure the Finger Guards are orient-
ed as shown.
42. Wrap the Leg Lever Cable (70) over a 90mm
Pulley (39). Attach the Pulley, a Small Cable Trap
(48), and two Half Finger Guards (42) at the sec-
ond hole from the bottom of the two Pulley Plates
(51) with an M10 x 48mm Bolt (102) and an M10
Nylon Locknut (114).
Make sure the Cable Trap
and Finger Guards are oriented as shown.
43. Wrap the Leg Lever Cable (70) under a 90mm
Pulley (39). Attach the Pulley and two Half Finger
Guards (42) to the “U”-bracket on the Right Base
(1) with an M10 x 45mm Bolt (101) and an M10
Nylon Locknut (114).
Make sure the Finger
Guards are oriented as shown and are on the
outside of the “U”-bracket.
44. Wrap the Leg Lever Cable (70) under a 90mm
Pulley (39). Attach the Pulley, a Small Cable Trap
(48), and two Half Finger Guards (42) to the
bracket on the Right Base (1) with an M10 x
48mm Bolt (102) and an M10 Nylon Locknut
(114).
Make sure the Cable Trap and Finger
Guards are oriented as shown and that the
bracket is between the Pulley and the Finger
Guard next to the Locknut.
45. Route the Leg Lever Cable (70) up through the
Right Top Frame (7), over a115mm Pulley (41),
and back down through the Top Frame. Attach
the Pulley inside the Top Frame with an M10 x
80mm Bolt (111), two M10 Washers (116), two
19mm Spacers (77), and an M10 Nylon Locknut
(114).
41
70
39
42
42
1
101
114
42
42
42
48
39
70
114
51
102
43
70
39
42
42
1
114
44
114
42
39
70
42
48
1
Bracket
102
45
70
116
111
114
77
77
41
7
101
116
