Wegener DTV742, User Manual

Page: 27 / 50

DTV 742 User’s Manual
wegener.com 27 800057-01 Rev. B
The right side of the screen selection of programs for inclusion in the multi-
plexers. There are 32 PID groups available for selection. A PID group is a set
of 16 PIDs which are used for all the PIDs associated with the selected pro-
gram - video, audio, and user data. The PIDs assigned to each PID group is
shown in Table 6. The PMT in a PID group is assigned to the first PID address
(e.g., PID group 1, PMT is address 0x020) and is followed by the video, audio,
and data PIDs.After each PID group on the Config In page are two boxes. The
first is the
Input box which is used to select which of the four RF inputs is
used for obtaining the input program. The second box ( Program ) is used to
select the program number to be used from that RF input. Note that a program
from a given RF input may only be placed in one PID group. An attempt to
place the same RF input and program number in two PID groups will result in
an error message. (Of course, Program 1 of RF Input 1 and Program 1 of RF
Input 2 may be selected in two PID groups because they are not the same pro-
gram.) After all desired programs have been selected, click
Submit
to activate
your selections.
After the Config In has been established, the output configurations for each of
the four ASI outputs may be set up.
Table 6: DTV742 PID Group (Pidset) Addresses
PID Group PID Addresses
1 0x020 to 0x02f
2 0x030 to 0x03f
3 0x040 to 0x04f
4 0x050 to 0x05f
5 0x060 to 0x06f
6 0x070 to 0x07f
7 0x080 to 0x08f
8 0x090 to 0x09f
9 0x0a0 to 0x0af
10 0x0b0 to 0x0bf
11 0x0c0 to 0x0cf
12 0x0d0 to 0x0df
13 0x0e0 to 0x0ef
14 0x0f0 to 0x0ff
15 0x100 to 0x10f