WEG PSRW, User Manual

Page: 53 / 59

Programming With WPS
PSRW | 9-19
9
„
If there are no further modifications exit from Prog-mode. Note that the Monitoring wizard also displays the
present state of the internal blocks by changing their colors. Thus, it is possible to connect the physical devices
to the PSRW and put them into operation to check that the created configuration is suitable for the actual
application in which the PSRW will be used.
Monitoring toggle-button
selected
Blue led on physical
PSRW de-activated
Buttons “Retrieve” and
“Exit from Prog-mode”
disabled
17
9 1
18 10
2
19 11
3
20 12
4
5
13 21
6
14 22
7
15 23
8
16 24
To ease this operation, you can do a right click on the title of any wizard tab and then click on “Float”.
„
De-select the toggle-button Connect Device .
„
Remove the USB cable.
„
Test if the new configuration on PSRW attends the needs of the safety monitoring application were it will be used.
9.7 RETRIEVING CONFIGURATIONS FROM PSRW
There are two ways to retrieve configurations from PSRW, one is through wizard Configurator Wizard and other
is through Wizard Monitor Wizard.
To do that, the connection has to be already setup (see Section 9.3 SETTING UP COMMUNICATION on page
9-7 ) and the buttons Connect Device and Monitor Device have to be activated.
Under those conditions, though wizard Configurator is necessary to click on Retrieve button . The
configurations will be loaded on the screen. Through Wizard Monitor, if the button Connect Device was
selected, the configurations from PSRW will be loaded automatically on the screen and they will change every time
that new configurations were transferred to PSRW.