Installation and Connection
CFW-11M G2 | 3-39
3
3.2.12.4 Typical Control Connections
Control connection 1 - Run/Stop function controlled from the keypad (Local Mode).
With this control connection it is possible to run the inverter in local mode with the factory default settings. This
operation mode is recommended for first-time users, since no additional control connections are required.
For the start-up in this operation mode, please follow instructions listed in
.
Control connection 2 - Wire Run/Stop function (Remote Mode).
This wiring example is valid only for the default factory settings and if the inverter is set to remote mode.
With the factory default settings, the selection of the operation mode (local/remote) is performed through the HMI key
LOC
REM
to remote mode (local mode is default).
Set P0220 = 3 to change the default setting of operator key
LOC
REM
to remote mode.
Run/Stop
Jog
Forward/Reverse (FWD/REV)
AH
H
≥5 kΩ
XC1 Terminal Strip
1
+ REF
2
AI1+
3
AI1-
4
- REF
5
AI2+
6
AI2-
7
AO1
8
AGND (24 V)
9
AO2
10
AGND (24 V)
11
DGND*
12
COM
13
24 Vdc
14
COM
15
DI1
16
DI2
17
DI3
18
DI4
19
DI5
20
DI6
21
NF1
DO1
(RL1)
22
C1
23
NA1
24
NF2
DO2
(RL2)
25
C2
26
NA2
27
NF3
DO3
(RL3)
28
C3
29
NA3
Figure 3.44:
XC1 wiring for Control Connection #2