4
COLD ENGINE STARTING OR
STARTING AFTER REFUELING
S
Set unit on a flat surface.
S
Slowly press the primer bulb 6 times.
S
Move choke lever to FULL CHOKE posi-
tion.
S
Squeeze the throttle trigger fully and hold
through
all remaining steps
.
S
Pull starter rope handle sharply 6 times.
S
Move choke lever to HALF CHOKE posi-
tion.
S
Pull starter rope handle no more than 6
pulls, until engine runs.
S
Allow engine to run 10 seconds, then move
choke lever to OFF CHOKE position.
RESTARTING A WARM ENGINE
S
Move choke lever to OFF CHOKE position.
S
Pull starter rope handle until engine runs.
S
If engine does not start in 5 pulls, follow
instructions in STARTING A COLD EN-
GINE.
USING YOUR UNIT
OPERATING POSITION
Eye Protection
Long Pants
Heavy Shoes
ALWAYS WEAR:
Cut from your right to your left.
ADVANCING THE CUTTING LINE
Advance line by tapping the bottom of the cut-
ting head lightly on the ground while engine is
running at full speed. The metal blade (Line
Limiter) attached to the shield will cut the line
to the proper length.
REPLACING THE LINE
S
Push and hold the engine stop switch in the
stop or off position until the unit has fully
stopped.
S
Disconnect the spark plug lead.
S
Remove spool by firmly pulling on tap but-
ton.
S
Clean entire surface of hub and spool.
S
Replace with a pre-wound spool, or cut a
length of 20 feet of .080” (2 mm) diameter
Weed Eater
r
brand line. Never use wire,
rope, string, etc., which can break off and
become a dangerous missile.
S
Insert one end of the line about 1/2 inch (1
cm) into the small hole on the inside of
spool.
Small
Hole
Spool
Hub
Line exit hole
Line in Notch
S
Wind the line evenly and tightly onto the
spool. Wind in the direction of the arrow
found on the spool.
S
Push the line into the notch, leaving 3 to 5
inches (7 -- 12 cm) unwound.
S
Insert the line into the the exit hole in the hub
as shown in the illustration.
S
Align the notch with the line exit hole.
S
Push spool into hub until it snaps into place.
S
Pull the line extending outside of the hub to
release it from the notch.
S
Reconnect spark plug lead before starting
unit.
SERVICE
We recommend all service and adjustments
not listed in this manual be performed by an
Authorized Service Dealer.
CARBURETOR ADJUSTMENTS
Your carburetor is equipped with limiter caps.
Carburetor adjustment is a complicated task.
We recommend that you take your unit to an
Authorized Service Dealer. Damage will oc-
cur if you turn the needles beyond the limiter
stops.
IGNITION TIMING
The ignition timing is fixed, non-adjustable.
SPARK PLUG
Replace the spark plug yearly using a Cham-
pion RCJ--8Y plug. Spark plug gap is .025”.
