8
END OF ANCHORING CROSSBAR
FLUSH TO EDGE OF RAILS
e)
Tighten clamp jaws with air wrench a little tighter than a wheel nut,
approximately 90 ft. lbs. (120 N.m) of torque.
f)
Repeat on opposite side. The pinchweld clamps should be positioned along the
pinchweld within 1 inch (2.5 cm) of each other, from side to side.
2.
Install the anchoring crossbars:
a)
Slide the 80” anchoring crossbar through the square hole in the bottom of the
pinchweld clamp and center the bar so that ends are flush to the outside edge
of floor rails.
b)
Insert wedges into the slot between the clamp and the underside of the
anchoring crossbar. The flat side of the wedge always goes against the bar.
Hammer the wedge into place firmly with a 3 lb. hammer.
