13
REMOVING A CAR FROM THE
ANCHORING SYSTEM
To remove a car from the anchoring system, reverse the set up procedure by following the
instructions below.
Chainless Anchoring System
1.
Loosen the rail lock nuts and remove the rail spacer wedges from all four
anchoring stands.
2.
IMPORTANT!
Remove the wedges from the top of the anchoring stand on all four
stands so that the cross bars may rotate freely on the anchoring stands before
jacking or lowering the car.
3.
Remove the wedges on the 72” anchoring side bars between the front and rear
clamps and remove the bars.
4.
Raise the rear end of the car. Remove the anchoring stands and remove the
wedges and the 80” anchoring crossbar. Remove the rear set of pinchweld clamps.
Lower the car and repeat the same procedure at the front end of the car.
