Weco Pioneer Pulse 321MKS, Instruction Manual, Page: 24 / 48

Cod . 006.0001.1600
11/07/2022 V.2.12
Pioneer 321 MKS
24
ENGLISH
5.2 PARAMETERS ACTIVATION
The welding parameters are available in accordance with the selected welding mode and procedure.
The table shows the settings required to enable each parameter.
KEY
1: Not enabled with manual program P0.
2: Always available.
- Parameters activation
PROCEDURE
MENU PARAMETER
1st WORKING VOLTAGE 2 2 1
1st INDUCTANCE 2 2 1
1st WIRE FEED RATE 2 2 1
1st WELDING CURRENT 1 1 1
1st THICKNESS 1 1 1
1st PROGRAMS 2 2 1
2° HOT-START 1
2nd CRATER FILLER 1
2nd 3 LEVELS SLOPE 1
2nd SOFT START 2 2 1
2° MOTOR SLOPE 2 2 1
2nd BURN BACK 2 2 1
GAS POST GAS TIME 2 2 1
GAS PRE-GAS TIME 2 2 1
5.3 WELDING PARAMETERS
WELDING CURRENT
Output current value during welding.
HOT-START
This function is useful when using aluminium alloy welding wire.
Consequences of a higher value:
- Greater heat output.
- Greater penetration.
Consequences of a lower value:
- “Cold” weld bead.
MOTOR SLOPE
Time required to switch from SOFT START speed to welding speed.
ARC CORRECTION IN VOLTS
This parameter corrects the synergic voltage value relative to the synergic point of the MIG/MAG pro -
cesses.
The default value for horizontal and frontal welding is 0.0 V.